here you go, sadly its not pin sharp as my scanned expects things to be flat on the glass, not a few mm above it ![:)]( "Smile")
obviously you're looking at the back, and top in the picture is what is regarded as the South side, and the left of the picture is the West side
so flip it top to bottom and you'll have it in top view orientation
looking at the four obviously vertical connectors , left most is the Modem/scsi connector, then the left side of the Co pro, then the unpopulated header, then the one of the right is the other side of the copro
a few of my own measurements - the spacing between the two copro headers (green arrows) is 5 3/4 inch (146.05 mm)
the distance from the western edge to the center of the eastern copro holes (orange) is 6 3/16 inch (157.1625mm)
and from the top (as photo'd) edge of the pcb to the lowest small hole center (Magenta) is 222mm
i'll drop the original scan to your email too
hope it helps
obviously you're looking at the back, and top in the picture is what is regarded as the South side, and the left of the picture is the West side
so flip it top to bottom and you'll have it in top view orientation
looking at the four obviously vertical connectors , left most is the Modem/scsi connector, then the left side of the Co pro, then the unpopulated header, then the one of the right is the other side of the copro
a few of my own measurements - the spacing between the two copro headers (green arrows) is 5 3/4 inch (146.05 mm)
the distance from the western edge to the center of the eastern copro holes (orange) is 6 3/16 inch (157.1625mm)
and from the top (as photo'd) edge of the pcb to the lowest small hole center (Magenta) is 222mm
i'll drop the original scan to your email too
hope it helps
Statistics: Posted by Ukwebb — Tue Jun 11, 2024 10:48 pm