Oh yeah, before I forget.
One thing that bothers me a bit is that the internal Pi Copro I have fitted in my Master 128, now rests on the side of the 12-bit extender board.
To prevent any kind of short, I applied 3 layers of Kapton tape to the underside of the Internal copro pcb.
But what bothers me the most, is that both the VideoNula with the 12-bit extender attached and the internal copro pcb can no longer be fully seated in the Master 128 board.
If I fully seat the Copro board, one side of the VideoNula lifts out of the socket.
If I fully seat the VideoNula, one side of the copro board lifts out of it's socket.
They are now both "somewhat" seated in their respective sockets.
I need to find a solution, probably an extender for the internal copro board to lift it about 5 mm higher.
One thing that bothers me a bit is that the internal Pi Copro I have fitted in my Master 128, now rests on the side of the 12-bit extender board.
To prevent any kind of short, I applied 3 layers of Kapton tape to the underside of the Internal copro pcb.
But what bothers me the most, is that both the VideoNula with the 12-bit extender attached and the internal copro pcb can no longer be fully seated in the Master 128 board.
If I fully seat the Copro board, one side of the VideoNula lifts out of the socket.
If I fully seat the VideoNula, one side of the copro board lifts out of it's socket.
They are now both "somewhat" seated in their respective sockets.
I need to find a solution, probably an extender for the internal copro board to lift it about 5 mm higher.
Statistics: Posted by Remklep — Sat Oct 12, 2024 11:13 pm